Barndominium Floor Plans With Shop: Sizes and Layouts That Work
The best barndominium floor plans with shop space start with the biggest thing you will ever park inside, not with the number of bedrooms. In Middle Tennessee that usually means a 40×60 or larger building with the shop on one end or in its own wing, a 12 to 14 foot overhead door, and a mudroom between the dirty side and the clean side. This guide covers shop sizes, door and wall heights, the layouts that work, the county rules that decide attached versus detached, and what the shop does to your budget and resale value.
For the broader picture of barndo layouts, start with our barndominium floor plans overview. This post goes deeper on the shop half of the building, because that is where most plans either earn their keep or quietly cost the owner for years.
How Big Should a Barndominium Shop Be?
Size the shop from the inside out. List every vehicle, trailer and machine you own or plan to own in the next ten years, measure the longest and tallest one, then add room to walk around it with a door open. People almost never regret a shop that is a bay too big. They regularly regret one that is a bay too small, because adding onto a steel or post frame building later means new footings, matching panels and a second permit.
Shop sizes by what you actually store
| What lives in the shop | Typical shop footprint | Overhead door | Eave (sidewall) height |
|---|---|---|---|
| Two cars plus a workbench | 24×30 to 30×40 (720 to 1,200 sq ft) | One 16×8 or two 10×8 | 10 to 12 ft |
| Compact tractor and implements | 30×40 to 40×40 | 12×10 or 12×12 | 12 to 14 ft |
| Bass boat or travel trailer | Add a 14×40 bay | 12×12 | 14 ft |
| Class A motorhome or fifth wheel | Add a 16×50 drive through bay | 14×14 | 16 ft |
| Car lift and fabrication work | 30×40 minimum | 10×10 or larger | 14 ft so a two post lift can reach full height |
These ranges come from the door and bay sizes that show up again and again in published shop house plans: 10×8 and 18×9 doors for car bays, 12×12 or 12×14 doors for RV bays, and roof heights in the 21 to 30 foot range when a lift or motorhome lives inside. Treat them as a starting point to take to a builder, not a spec.
The 13 foot 6 inch number every RV owner should know
Tennessee’s legal height limit for vehicles on its highways is 13 feet 6 inches. Most Class A motorhomes are built to sit just under it, often 12 to 13 feet before you count the air conditioners and antennas on the roof. That is why a 12 foot door is the most common RV shop mistake in the state. Measure your rig with everything on the roof, plan a 14 foot tall door, and give the bay a 16 foot eave so the door’s track and opener have somewhere to go.
Barndominium Floor Plans With Shop Space: Four Layouts That Work
1. The split rectangle (40×60 with shop on one end)
The simplest and cheapest plan. A 40×60 building is 2,400 square feet, and the common split puts 1,600 square feet of living space on one end and a 40×20 shop on the other, or 1,200 and 1,200 if the shop matters more than a third bedroom. One roof, one slab pour, one set of trusses. The tradeoff is that the shop shares a full wall with the house, so noise, fumes and fire separation all have to be designed in rather than solved with distance.
2. The L shape or shop wing
The living area runs one direction and the shop runs off the end at a right angle, often with the overhead doors facing a different side of the property than the front porch. It costs more than a rectangle because of the extra roof valley and corner framing, but it lets you hide the shop doors from the road, which helps both curb appeal and resale.
3. Shop below, living above
The true shouse. A tall shop on the ground floor with an apartment or the main living quarters upstairs. It packs the most usable space onto the smallest footprint, which matters on a tight or sloped lot. It also triggers the strictest fire separation rules in the code, needs a real staircase, and is the hardest layout to sell to a buyer who is not a shop person.
4. The breezeway or detached shop
A covered breezeway, or a fully separate building 20 to 100 feet away. You lose the convenience of walking from the kitchen into the shop in socks, but you gain quiet, cleaner air in the house, and a shop that can be insulated, heated and insured on its own terms. As the next section explains, detached shops also run into a different set of county rules.
Attached vs Detached Shop: The Tennessee Rules That Decide It
Tennessee builds homes to the 2018 International Residential Code as amended by the state, in effect since July 16, 2020. Counties inspect against it, and how the code treats your shop depends on whether it is part of the house or a separate building.
If the shop is attached
An attached shop that holds vehicles is treated like an attached garage. Expect these requirements, and confirm them with your county building department because local amendments vary:
- At least 1/2 inch gypsum board on the shop side of the wall shared with the house.
- 5/8 inch Type X gypsum on the shop ceiling when there are living spaces above it, plus protection on the structure that holds that floor up.
- A solid wood or steel door at least 1 3/8 inches thick, or a 20 minute fire rated door, between the shop and the house, self closing and self latching under the 2018 code.
- No door from the shop directly into a bedroom.
- Ducts in the shop made of at least 26 gauge steel, with no openings into the shop, and sealed penetrations wherever pipes and wires pass through the separation wall.
On a post frame or steel building those rules affect framing choices early, which is one more reason to settle the layout before you pick between post frame and red iron.
If the shop is detached
A separate shop is an accessory structure, and accessory structures come with zoning limits. Published summaries of the Rutherford County zoning resolution cap the combined size of detached accessory buildings at 2,000 square feet on lots of one acre or less, or 5% of lot area on larger lots, and say an accessory building cannot go up before the house without a special exception from the Board of Zoning Appeals. A recent Rutherford case involved an unpermitted 40×80 metal building put up before any house. Maury County also expects the home before the shop. Unincorporated Williamson County requires accessory uses to stay incidental to the home and requires a permit for larger accessory buildings.
If you want living quarters in a detached shop, Rutherford County treats that as an accessory dwelling unit, with a one acre minimum lot, an owner occupancy covenant and a 300 square foot minimum. Ask before you plumb a bathroom out there. If you are shopping land in Rutherford County or Maury County, confirm acreage and zoning against the shop you want before you make an offer, and our barndominium land checklist walks through the other questions to ask.
Running a Business Out of the Shop
Plenty of shop buyers are welders, mechanics, woodworkers or contractors who want to stop paying rent on a commercial bay. That can work, but zoning sees a customer driveway differently from a hobby. Metro Nashville requires a home occupation permit, and the property has to be the permit holder’s primary residence. County rules elsewhere vary on employees, customer visits, signs and outdoor storage, and a small business tucked into a shop is a very different request from a commercial operation with daily deliveries.
Insurance is the other surprise. A standard homeowners policy typically covers only a few thousand dollars of business property on the premises, which will not cover a welder, a lift and an inventory of parts. Our barndominium insurance guide covers how other structures and business property limits work.
What the Shop Does to Your Budget and Resale Value
Shop space is cheaper to build
Shop space mostly costs what the shell costs. 2026 national cost guides put an erected metal shell at roughly $30 to $50 per square foot, while finished living space with drywall, flooring, mechanicals and fixtures typically runs $120 to $185 or more. That is why a big shop pulls the blended cost per square foot down and why quotes that only show the blended number can mislead you. Ask every builder to price the living area and the shop separately. Our Tennessee cost to build guide covers impact fees, septic and the rest of the budget.
But appraisers do not count it as living area
Shop square footage is not heated living area, so an appraiser values it separately and usually at a fraction of what it cost. A 2,400 square foot building with 1,200 square feet of living space appraises as a 1,200 square foot home with a large outbuilding style garage. Plan your down payment around that, and read the barndominium financing basics before you commit to a big shop on a construction loan. The barndominium resale value post explains how comparable sales shape that number.
Rough in these now, not later
- A thicker slab, often 6 inches with heavier reinforcement, under any bay that will hold a tractor, RV or lift.
- A 240 volt subpanel sized for a welder, compressor and future EV charger.
- Conduit for compressed air and data along the walls before the liner panels go up.
- A half bath or utility sink by the shop door. Ask the county before adding a floor drain, because oily wash water cannot go into a septic system.
- Insulation and vapor control that stop the dripping ceiling problem described in our barndominium insulation guide.
Layout Details That Matter at Resale
The shop house plans that sell well in Middle Tennessee tend to share a few habits. Bedrooms sit on the far side of the building from the shop wall, with closets or a laundry room acting as a sound buffer. A real mudroom with a bench, hooks and a washer sits between the shop and the kitchen so dirt and diesel smell stop there. Overhead doors face the driveway, not the road, with a gravel or concrete apron deep enough to back a trailer in without a three point turn, often 50 to 60 feet. And the shop has its own man door, so nobody walks a lawn mower through the house.
The plans that sit on the market usually broke one of those rules, or put so much of the budget into the shop that the living side feels like an afterthought. A future buyer may love the shop, but they will be living in the house.
Frequently Asked Questions
What is the most popular barndominium floor plan with a shop?
A 40×60 rectangle with roughly 1,600 square feet of living space and a 40×20 shop on one end is the most common starting point. It keeps the roof and slab simple and leaves room to grow the shop into a separate building later.
How tall should a barndominium shop door be for an RV?
Plan a 14 foot tall door and about a 16 foot eave. Tennessee limits vehicles to 13 feet 6 inches, and most Class A motorhomes sit close to that once roof equipment is counted, so a 12 foot door is often too short.
Is an attached or detached shop better for a barndominium?
Attached is cheaper and more convenient but needs fire separation, a rated door and good sound control. Detached is quieter and cleaner but counts as an accessory building, so county size caps and house first rules apply. Check zoning on the specific parcel before deciding.
Does shop space count toward a barndominium appraisal?
Not as living area. Appraisers value the heated living space using comparable sales and add a separate, usually lower, value for the shop, so a big shop rarely returns its full cost at appraisal.
Can I live in a barndominium shop while I build the house?
Usually not without approvals. Rutherford County requires the house before accessory buildings unless the Board of Zoning Appeals grants an exception, and living quarters in a shop are treated as a dwelling unit with their own permit and septic requirements. Ask the county first.
Plan Your Barndominium
Ready to go from reading to building? Start with the land, the loan or the build package.
The Barndominium Section
Land, financing, floor plans and a licensed builder for your barndominium in Middle Tennessee.






